Hunter PC-DM Decoder Module for PRO-C

Product Description PC-DM Decoder Module for Pro-C The Pro-C controller is supplied with a base 4-station module. The Pro-C is also compatible with the EZ Decoder System (EZDS) for hybrid conventional and two-wire operations. Add a Pro-C Decoder Module (PC-DM) to enable control for up to 32 total stations. This system uses the same EZ-1 decoders used with ICC2 and HCC controllers. Combined with web-based management tools the EZDS greatly simplifies irrigation management. Simple push-button programming of decoders without the need for serial numbers Electrical output on two-wire path: 24 VAC, 50/60 Hz Up to two standard 24VAC solenoids per EZ-1 decoder output Two-wire paths allow for tee-splicing in different directions EZ-1 Decoders are rated IP68, submersible Reliable operation over 600m, depending on wire size Up to 54-station capacity, plus master valve No special wire or connectors required Allows hybrid operations of conventional and decoder stations Compatible with any direct-burial wire The PC-DM can only be installed in the last two station output slots (similar to PCM-900 and PCM-1600 installation). The PC-DM will not physically fit or operate in any other station output slot. IMPORTANT: While the addition of this module increases total station count to 32, the first 4 stations cannot be programmed as decoders and must be wired conventionally to the 4-station master module. This leaves stations 532 available for EZ decoder operation. This allows for hybrid conventional/decoder operation. If only EZ decoders are to be used, there are 28 total stations available, and the first station must be programmed as station 5. *Please note: Only compatible with units manufactured from FEB 2020* Features Two-wire decoder system for Pro-C controllers Up to 28-station capacity, plus master valve Wire paths possible for over 1 km; see wiring table No special grounding or surge arrestors required in-line EZ-1 single-station decoders have status LED for positive diagnostics P/MV can be activated by decoder or direct controller output EZ-DM output module works in any controller module slot EZDS Wiring Distances International Wire Distance* 0.8mm 267m 1mm 333m 1.5mm 500m 2.5mm 833 4mm 1333m *Distances in the wiring table are calculated based on 50 Hz, with wire temperature of 50C and a 10% safety factor Click for Product Data Sheet Videos Hunter EZ Decoder System Product Guide. The simple two-wire solution. Hunters brand-new EZ Decoder System revolutionizes traditiona…